#
# Copyright 2007 Sun Microsystems, Inc.  All rights reserved.
# Use is subject to license terms.
#
#ident	"@(#)kbd.dfl	1.6	07/04/03 SMI"
#
# /etc/default/kbd
#
# kbd default settings processed via kbd(1).
#
# KEYBOARD_ABORT affects the default behavior of the keyboard abort
# sequence, see kbd(1) for details.  The default value is "enable". The
# optional values are "disable" or "alternate". Any other value is ignored.
# If you choose "alternate" it will affect the serial console drivers  ONLY.
# The keyboard BREAK (sequence and plug/unplug) won't be affected by this.
# If "alternate" is in effect any protocol (PPP, SLIP... etc) should not be
# run over the serial console port.
#
# KEYCLICK affects the default keyclick behavior. Possible values are
# 'on' and 'off'.  Any other value is ignored. The default behavior is
# to leave the current keyclick setting unchanged.
#
# Uncomment the following line to disable keyboard or serial device
# abort sequences:
#KEYBOARD_ABORT=disable

# Uncomment the following line to enable a non-BREAK alternate
# serial input device abort sequence:
#KEYBOARD_ABORT=alternate

# Uncomment the following line to change the keyclick behavior:
#KEYCLICK=off

# Uncomment the following lines to set up autorepeat delay and rate,
# units in milliseconds:
#REPEAT_DELAY=500
#REPEAT_RATE=33

# Uncomment the following line to set up the keyboard layout. The 
# keyboard layouts supported can be listed by running 'kbd -s'.
# The value will override the keyboard-layout value supplied in eeprom
# if it exists in eeprom when system boots.
#LAYOUT=